Pair of Oxygen Sensor Upstream Downstream For 2007-2011 Honda Element 2.4L l4

Fit Vehicles:

For 2003-2011 Honda Element 2.4L

Features:

• Extensively Tested During Manufacture to Guarantee Quality and Reliability

• Supplied With a Factory-Fitted Connector for Easy Installation

• Precision manufactured with a sensing element incorporating premier technical ceramics

Where are my oxygen sensors located

Diagnostic Trouble Codes (DTC)

When oxygen sensor failure occurs, a DTC is recorded in the Engine Control Unit (ECU) and a Malfunction Indicator Lamp (MIL) is illuminated on the dash, alerting the driver the vehicle has a problem.

How to replace an oxygen sensor

1- Disconnect the battery.

2- Locate the sensor connector by following its wires. Disconnect it.

3- Remove the sensor cable from its clips all along its way to the sensor.

4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.

5- Remove the sensor and fit the new one.

6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.

7- Reconnect the battery and wait 5 minutes before starting the engine.

Please take a video clip of the voltmeter and contact us if our sensor:

Goes above range between 0.1 and 0.9 volt
Remains below 0.5 volts
Stays fixed at a particular voltage
You're free to choose replacement or refund if our sensor fails to work, in this case.