Labwork Power Steering Pump For 2001 2000 1999 1998 1997 Honda Civic CRV CR-V Acura EL

Fit:
For 1996-2001 Honda Civic CR-V Acura EL

Part Number:
AA1215066, FENSP15012, 55-5333, 55-5711, 21-5066,56110P2A963, 56110P3F003, 56110P3F013,56110P2A003, 56110P2A013, 56110P2A023, 56110P2A962

Package Included:
1x Power Steering Pump

Notice:
* Professional installation is highly recommended (No Instruction Included)
* For any needs please contact us!

INSTALLATION GUIDE
1. Only use the first class FLUID type, never use no brand lower quality fluid.
2. FLUSH the old fluid from entire system.
3. Install a FILTER to prolong pump service life.
4. Inspect and replace any hose that is damaged, worn or aged.
5. Remove and install pump pulley using proper tools and procedures.

REMOVE ORIGINAL PUMP
1. Use a suitable puller to remove pressed-on pulleys (if so equipped).
2. Remove pressure and return lines from the pump. If reused, thor-
oughly clean fittings and flush lines. Cap lines to keep dirt out of the system.
3. Remove drive belt if applicable.
4. Remove and transfer all switches, sensors, brackets, retaining hardware and special parts not supplied with replacement unit; clean and repair or replace as needed.

FLUSH THE SYSTEM
Old fluid must be flushed from hydraulic hoses, steering unit and hydro boost (if so equipped). Power flushing is an option, but manual flushing methods are preferred. Regardless of technique used, all old fluid MUST be flushed from the system and then replaced with OEM-approved new fluid type. Failure to properly flush the system, and not using the correct fluid will VOID THE UNIT WARRANTY.

BLEEDING AND TESTING
1. Before operating the system, check fluid levels, prime the pump, and check that pulleys and belts are clear of obstacles and routed correctly.
2. If possible, crank engine in short bursts to circulate fluid and allow any trapped air to rise toward the reservoir.
3. Start engine and check fluid levels. If fluid level drops, this is an indication that air is still in the system. It may be necessary to vacuum bleed the system using appropriate tools and procedures.
4. If noisy operation persists or fluid stays foamy, a restriction in the system may be the cause. Check for damaged or defective hoses, a blocked reservoir filter, a blocked remote reservoir hose, or a blocked or restricted cooler (if so equipped). Prolonged operation with any of these conditions will affect operation and cause premature pump failure.